After all skips, broken threads or other mistakes have been corrected, the yardage can be fulled. Be brave, but please also be very careful as your lovely blanket can quickly turn into a piece of felt, perhaps good for felted slippers but not the fluffy blanket you had hoped for.

In order to full my newly woven blankets, I fill my washing machine with hot water and add some laundry detergent. I then place the blanket into the washer. I turn the washing machine on, and stand by it watching the blanket agitate. Time this process and check the blanket every 30 seconds. Turn the washer off and pull out part of the blanket to check on the amount of fulling that has occurred. Turn the washer back on and let agitate another 30 seconds and again check. This fulling process usually takes about 2 - 3 minutes.

The spinning oils and lanolin are removed with washing. The heat and agitation begin the felting process in the wool, opening up the individual fibers and interlocking them together.

When the individual threads no longer move separately, but begin to join together, and the yardage starts to look more like fabric or a blanket (as it should), then stop the washer. If you are not sure if it has agitated enough, it is better to stop than continue, as you can always full the yardage further if need be, however, it is not possible to go back.

Drain the water out of the washer - without turning on the spin cycle. Refill the washer with cool water to rinse out the fabric but without agitation or spin cycle. Drain the water from the washer, and then turn on the spin cycle for about 30 - 60 seconds to remove the remaining water from the blanket.

Hang the finished blanket to dry. Enjoy!